Knowledgebase: FDM
Error 404 Not Found when Performing Drill Through from Smartview Planning to FDM
Posted by Priya Doyle on 08 February 2011 03:46 PM

Error 404 Not Found when Performing Drill Through from Smartview Planning to FDM

 Modified 19-APR-2010     Type PROBLEM 

Applies to:

Hyperion Financial Data Quality Management - Version: 11.1.1.3.00 and later   [Release: 11.1 and later ]
Hyperion Planning - Version: 11.1.1.0.00 and later    [Release: 11.1 and later]
Information in this document applies to any platform.

Symptoms

When attempting to drill though from SmartView connected to a Planning Data Source to Financial Data Quality Management (FDM), the following error occurs:

Error 404 Not Found

From RFC 2068 Hypertext Transfer Protocol - HTTP/1.1:

10.5.5.404 Not Found

The server has not found anything matching the Request-URL. No indication is given of whether the condition is temporary or permanent

If the server does not wish to make this information available to the client, the status code 403(Forbidden) can be used instead. the 410 (Gone) status code SHOULD be used instead, if the server knows, through some internally configurable mechanism, that an old resource is permanently unavailable and has no forwarding address 

Cause

The http server cannot redirect the requests from the Analytic Provider Services (APS) because APS has not been deployed to workspace. 

Solution

Redeploy Workspace by performing the following procedure:

Launch EPM System Configuration Tool > From the Product to configure select Hyperion Foundation > Workspace > Configure Web Server.  

For further information on deploying workspace refer to the EPM System Installation guide.

(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments: